tangential load

The system software from the EMS dispatching automation system and centralized UFLS device acquires the real-time observation data, low frequency on-line calculation and scheme of setting calculation ( Tangential load ratio or capacity).

该系统软件通过从EMS调度自动化系统和集中式低频减载装置实时获取观测数据，实现低频在线计算与方案整定计算（切负荷比例或容量）。

互联网摘选

In the strategy, two regulators, combining with a switch, control the tangential sway of the load during the slewing motion and the sway after the load arriving at its destination respectively.

该方案通过1个切换开关将2个最优调节器结合起来分别控制吊重在回转运动中的切向摆振和到达目标位置后的摆振。

互联网摘选

The tangential load of the RWD string, i.e. the torsion load, does a striking effect on its deformation and strength.

随钻扩眼钻柱所受的周向载荷，即扭转载荷对变形和强度影响显著。

互联网摘选

Considering the tangential force applied on a contact spot, the critical area demarcating the elastic and plastic regimes is obtained by comparing the normal elastic load with the normal plastic load.

计及作用于接触斑点上的切向力，通过比较作用于接触斑点上的法向弹性载荷与法向塑性载荷，确定了区分弹性接触与塑性接触区域的临界接触斑点面积。

互联网摘选

This paper presents two kinds of influence function formulae due to either suddenly or harmonically acted tangential load uniformly distributed over a circular area on the surface of an elastic half-space.

本文提出了弹性半空间表面上作用圆形均布水平突加力或谐和力时的两类影响函数式；

互联网摘选

The results show that opening point, opening angle, maximal tangential stress and critical load vary with aspect ratio and inclined angle. The most dangerous inclined angle is obtained accordingly.

结果表明，开裂点、开裂角、最大切向拉应力和临界载荷随椭圆的纵横轴比和倾角的不同而变化，由此可得到最危险的倾角。

互联网摘选

In the printing process, when moving the target substrate, and then pulling the stamp, the two interfaces stand the normal load and tangential load.

印刷过程中，移动目标基体，然后提起印章，界面受法向载荷和切向载荷共同作用。

互联网摘选

The analytic solution to hyperelastic half space with arbitrary tangential load

任意切向荷载下超弹性半空间的解析解

互联网摘选

The surface micro-cracks and/ or micro-cracks in the substrate are yielded as results of normal load and tangential load;

机械力导致表面裂纹或表面层裂纹的产生；

互联网摘选

When the side surface is under simple shear load and has a tangential deformation, stress concentrations occur at the fixed end of yarns which are the main load-bearing bodies.

当模型的侧面受到简单剪切而产生切向变形时，在主承载纤维束的固定端产生应力集中。

互联网摘选